Wood Pullout Cabinet Drawer Organizer
After organizing my junk drawer successfully, I felt confident and inspired to tackle some more cabinet storage. And of course, first up, what to do with all the princess plates, lunchroom trays and sippy cups with missing lids.
1 - 1x6 @ 8 feet long
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Cut to fit your cabinets.
The first thing you need to do is measure the opening of your cabinets and the depth of your cabinets. Mine had a clearance opening (the hinges took up a little room too) of 14 1/2". Remember that your drawer slides also take up 1" all for both, so that's a total drawer width of 13 1/2". To be safe, I made mine 13" wide, and cut 2 1x6s to this length. Then I measured the depth of the opening. Mine was 22 3/4" deep. So I cut the 2x2s to the depth of the cabinet and then cut the two 1x6s to this measurement minus 1 1/2" - so for me, 21 1/4". I then cut the 1/4" plywood to 13" x 22 3/4".
With all the boards cut, I built a simple box (used 1 1/4" pocket hole screws but you could also use 2" screws countersunk) and glue. The I tapped the bottom on with 1 1/4" finish nails and glue.
Because these cheapo drawer slides (that actually work really well and are quite strong) are side/bottom mount, you can get away with just tacking 1/4" plywood to the bottom. The weight of the drawer contents sits right on the slides. I attached the two drawer parts of the slides to the bottom of the drawer as shown above.
Then I attached the remaining drawer slide pieces to the 2x2s as shown here. Make sure these pieces are attached level and in the same position on both 2x2s. This is important. I used the screws that came with the slides, and followed the directions on the slides.
And now it's time to test it out. I just screwed the 2x2s directly to my workbench and oh yeah! it works!
Then I simply positioned the whole setup inside the cabinet, and because of the tight fit, screwed the 2x2s to the shelf from the underside. But if you had more clearance from the top, you could screw from the top too. Used 2" screws here, just two per 2x2.
And then just put the drawer in. The drawer is easy to remove and clean (and in my case, finish) and I really love the 2x2s in there, because they keep things from sliding under your drawer. Off to build . . . six more.