Make a window birdfeeder from scrap wood!
1 - 1x8 @ 18" long
1 - 1x3 @ 15" long
1 - 1x2 @ 16" long
Glue and 1 1/4" nails
4 suction cups and screws
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
1 - 1x8 @ 14" (main piece)
1 - 1x8 @ 2 1/2" (tray bottom)
2 - 1x3 @ 7" (top end cut at 45 degrees off square - roof) - NOTE: You could cut one at 6 1/4" and one at 7" and attach to form the roof if you do not have a miter saw
2 - 1x2 @ 3 1/4" (tray sides)
1 - 1x2 @ 8 3/4" (tray front)
From the 1x8 cut out the back as shown above. I used a jigsaw to cut center out. I highly recommend sanding your cut at this stage - it'll be much easier to sand now than after the little birdie feeder is assembled.
Then add the bottom tray. I used glue and 1 1/4" finish nails.
I went ahead and built the roof first. then attached it to the back with 1 1/4" finish nails and glue. Lots of glue.
Now the sides. Make sure you attach to back and bottom.
And finally the tray front.
From here, I added the suction cups to back.