I have a Delta 10" chop saw that I'm not using, and haven't used in a couple of years. I just checked at Menards, and the same saw sells for $130. I'd like to see this saw go to somebody who is just getting started and needs a leg up. If you're in southeast Michigan I'll sell you the saw for $50.
The saw isn't anything special. It's a 10" saw with an aluminum rotating table and a tilt adjustment. It doesn't have any slide, which means it won't be cutting anything wider than 6". It's great for cutting trim and cutting 1x4/1x6 to length.
The table does seem to attract grit which wedges between the steel frame and the aluminum table. The problem was probably due to using it in a garage with a dicey roof, and if you're not doing that you'll be fine. In any event, if you buy this I'll show you how to fix the problem and tune up the saw.