Updated Tryde Coffee Table - Pocket Holes
Updated plans for the Tryde Coffee Table. Build your own solid wood rustic coffee table! Free plans from Ana-White.com
6 - 2x4 @ 8 feet long
1 - 4x4 @ 6 feet long
100 - 2 1/2" Pocket hole screws, coarse thread
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
8 - 2x4 @ 47 1/2"
2 - 2x4 @ 28" (recommend cutting to fit after step 1)
2 - 2x4 @ 18"
2 - 2x4 @ 42 1/2"
4 - 4x4 @ 16 1/2"
Start by building the table top boards. Clamp each joint and attach with 2 1/2" pocket hole screws. Make sure your ends are flush. If they are not, you will need to cut ends flush with a circular saw before attaching breadboard ends.
measure width of tabletop and cut breadboard ends. Attach breadboard ends to the tabletop as shown above, with ends flush.
Set the tabletop aside.
Now let's move on to the legs.
Take a scrap piece of 1/2" plywood and use it as a spacer to elevate your apron when attaching to the legs to get the 1/2" inset. Remember to face the 1 1/2" pocket holes in the aprons facing upward for attaching the tabletop in last step.
Build two end aprons/leg sets.
Then attach the two leg sets together to form the tabletop base with the side aprons. Remember to keep the pocket holes for attaching the tabletop later on facing upward.
Position the base on the underside of the top, keeping overhangs even all the way around. Attach with 2 1/2" pocket hole screws and glue.