Clothesline Frame

Primary tabs

PDF versionPDF version

About This Project

I loved the simplicity of this project. I scaled down the original size, to make the 1x3's 33 inches high by 22 inches wide. I also went with my kreg jig set at 1/2" and used 1" screws. I did this because I cracked the first board without even blinking when the kreg jig was set to a depth of 3/4", using 1 1/4" screws.

Fir
Required Skill Level: 
Starter Project
Estimated Time Investment: 
An Hour or Two (0-2 Hours)
Finish Used: 
Minwax Express Finish in Walnut
Estimated Cost: 
$15