4 - 2x4 @ 8 feet long
1 - 4x4 @ 10 feet long
4 - 2x8 @ 6 feet long
1 - 2x8 @ 8 feet long (breadboard ends)
1 - 2x10 @ 6 feet long
4 - 4x4 posts @ 29" (legs)
2 - 2x4 @ 67" (long aprons)
2 - 2x4 @ 27" (short aprons)
1 - 2x4 @ 74" (stretcher)
2 - 2x4 @ 34" (stretcher supports)
4 - 2x8 @ 70.5" (table top planks)
1 - 2x10@ 70.5" (center table top plank -- I had to use one 2x10 to get the right overall width)
2 - 2x8 ~38" (breadboard ends -- measure your joined tabletop before cutting these)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
First, cut and notch out the 4x4s. If you can get your home improvement store to make square cuts, ask them to cut your 4x4s. Otherwise, you'll need a 12" (maybe a 10" will work too) miter saw or set your circular saw to the deepest possible cut. Cut one side, flip the 4x4 and finish the cut on the bottom side. Sand until cut is smooth. You'll probably add cork or felt pads under the legs later on to level table up and protect your floor.
Then notch out the stretcher joint as shown in diagram. Definitely practice first on a scrap if you can. This is easier to do than it looks - just be sure to get the top and bottom cut right, and it will all work out!
Notch out the stretcher support board first, then attach to the 4x4s. Remember the screws will show here, so drill in pattern. Use 3" screws to attach.
Do both ends.
Free plans to build a Farmhouse Table. This plan uses pocket holes and is the updated plan.
Then add your top aprons with 1 1/2" pocket holes and 2 1/2" pocket hole screws.
NOT SHOWN: Drill 1 1/2" pocket holes on the insides of your aprons facing upward for later attaching the the tabletop too. Drill three holes per end apron.
Now attach the two ends together to create your table frame.
NOT SHOWN: Drill 1 1/2" pocket holes on the insides of your aprons facing upward for later attaching the the tabletop too. Drill five holes per side apron.
Add the stretcher with 3" screws.
Now start building your tabletop.
Measure and cut your breadboard ends to fit and attach to tabletop.
Then attach the base to the tabletop through predrilled 1 1/2" pocket holes with 2 1/2" pocket hole screws.