Truss Coffee Table
Truss Coffee Table
Free plans to build a truss style coffee table from ana-white.com
3 - 2x6 @ 8 feet long
3 - 2x3 @ 8 feet long
For attaching, you can use countersunk screws (3" wood screws) or 2 1/2" PH screws and glue.
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
4 - 2x3 @ 16 3/4" (legs - both ends cut at 10 degrees off square BEVEL long point to short point, ends ARE parallel)
4 - 2x3 @ 19" (end stretchers)
1 - 2x3 @ 37 3/4" (bottom stretcher - both ends cut at 10 degrees off square ANGLE long point to long point ends are NOT parallel)
1 - 2x3 @ 33 3/4" (top stretcher - both ends cut at 10 degrees off square ANGLE long point to long point ends are NOT parallel)
2 - 2x3 @ 20" (truss detail - cut down to make up truss parts - if you saw cuts 55 degree angles, you can also cut these with ends parallel at 55 degrees off square, long point to short point, 15" long)
5 - 2x6 @ 48" (tabletop)
First, build your two leg ends. They will be identical. You can use 1 1/2" PHs on each end of the aprons and 2 1/2" screws to attach, or you can attach from outsides with screws and glue. If you choose to countersink, first drill a hole the size of your screw head 1 1/2" into the leg. Then attach your screw, countersinking the head into the leg 1 1/2".
NOTE: If you plan to attach top with pocket holes (see step 5) then drill 1 1/2" PHs facing upward on insides of top aprons.
Find the centers of your end stretchers and attach the top and bottom stretchers with 2 1/2" to 3" screws or with pocket hole screws and glue.
If your miter saw cuts a 55 degree angle, cut your truss boards and fit in place. Otherwise, cut the truss boards to 20" length and set in place and mark angles by hand. Cut the angles with a circular saw and fit in place.
I recommend building tabletop first with 1 1/2" PHs and 2 1/2" PH screws, or edge gluing and clamping to create your tabletop.
Then attach the top to the base. The diagram details multiple methods. In addition, you can use brackets to attach.