This was a fun weekend project! Built from Plan(s) Rustic X Coffee Table Estimated Time Investment Weekend Project (10-20 Hours) Recommended Skill Level Beginner Comments nkfuller09 Wed, 10/29/2014 - 13:28 bottom? Hey great job! Just wondering if you used 2x6 for the bottom as well and if the table ended up being very heavy due to it? Thanks :) Log in or register to post comments In reply to bottom? by nkfuller09 Jodie Thu, 12/31/2015 - 07:16 I used 1x6's, i think 2x6's I used 1x6's, i think 2x6's would've made the table much too heavy... it is already extremely heavy, but super sturdy as well! Log in or register to post comments sergiontami Tue, 01/16/2018 - 16:26 Corner Brackets? Just wondering where you got them from? We've been looking all over the internet and have yet to find them... Log in or register to post comments In reply to Corner Brackets? by sergiontami Jodie Sat, 06/23/2018 - 12:15 I fashioned them myself out I fashioned them myself out of some flat steel brackets. I bent them to 90 degree angles in a vice, then spray painted them black. Log in or register to post comments Log in or register to post comments
nkfuller09 Wed, 10/29/2014 - 13:28 bottom? Hey great job! Just wondering if you used 2x6 for the bottom as well and if the table ended up being very heavy due to it? Thanks :) Log in or register to post comments
In reply to bottom? by nkfuller09 Jodie Thu, 12/31/2015 - 07:16 I used 1x6's, i think 2x6's I used 1x6's, i think 2x6's would've made the table much too heavy... it is already extremely heavy, but super sturdy as well! Log in or register to post comments
sergiontami Tue, 01/16/2018 - 16:26 Corner Brackets? Just wondering where you got them from? We've been looking all over the internet and have yet to find them... Log in or register to post comments
In reply to Corner Brackets? by sergiontami Jodie Sat, 06/23/2018 - 12:15 I fashioned them myself out I fashioned them myself out of some flat steel brackets. I bent them to 90 degree angles in a vice, then spray painted them black. Log in or register to post comments
Comments
nkfuller09
Wed, 10/29/2014 - 13:28
bottom?
Hey great job! Just wondering if you used 2x6 for the bottom as well and if the table ended up being very heavy due to it? Thanks :)
In reply to bottom? by nkfuller09
Jodie
Thu, 12/31/2015 - 07:16
I used 1x6's, i think 2x6's
I used 1x6's, i think 2x6's would've made the table much too heavy... it is already extremely heavy, but super sturdy as well!
sergiontami
Tue, 01/16/2018 - 16:26
Corner Brackets?
Just wondering where you got them from? We've been looking all over the internet and have yet to find them...
In reply to Corner Brackets? by sergiontami
Jodie
Sat, 06/23/2018 - 12:15
I fashioned them myself out
I fashioned them myself out of some flat steel brackets. I bent them to 90 degree angles in a vice, then spray painted them black.