Toy or TV Armoire Drawer Insert
Free plans to build a drawer insert for an armoire from Ana-White.com
Shopping List - you may have leftover from the toy armoire
Plywood ripped into 21 3/4" widths - about 10 feet (use same rip width as the armoire)
4 - 1x6 @ 8 feet long
1 - 1x8 @ 8 feet long
4 sets euro drawer slides, 21" length
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
2 - 3/4" plywood 21 3/4" x 36" (top and bottoms)
3 - 3/4" plywood 21 3/4" x 15 1/2" (dividers and sides)
8 - 1x6 @ 21" (sides)
8 - 1x6 @ 15 7/8" (front/backs)
4 - 1/4" plywood @ 21" x 15 7/8" (bottoms)
4 - 1x8 @ 16 5/8" (faces)
You'll definitely want to build yours to fit - so take a second to measure the inside of your toy armoire and check to see if it's about 1/2" larger than the insert. Adjust if necessary - you want this insert to be able to fit inside, but not so tight it's a battle to get it in.
Then build the basic box for the drawers. Because we will be adding drawers, you must be very very precise and make sure the box is square or your drawers will not slide right.
I highly recommend a pocket hole jig just to ensure that your joints are square. If you use countersunk screws, you may wish to add back plywood to keep the box square.
Next, build your four drawers as shown above.
Insert drawers into box.
Attach faces to front.
Finish and insert into the toy armoire!