Compound Miter Saw
Drill with Countersink Bit
1 - 2x4 8 feet long or stud length
1 - 1x4 @ 12 feet long
2” and 2 1/2” exterior screws
2 - 2x4 @ 23 1/2” long with both ends cut at 30 degrees off square, parallel to each other, long point to short point measurement (stringers)
5 - 1x4 @ 22 1/2” (top boards)
2 - 2x4 @ 13 3/4” long with one end cut at 30 degrees off square, longest point measurement (legs)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Trim off that bottom of your stretchers like this ....
Add the decking on top either with nails or screws
Build an adirondack footstool - super easy tutorial!
And then just put the legs on and flip it over!
Enjoy your footstool!