Build this wood console! Free plans from Ana-White.com
2 - 2x6 @ 10 feet long
1 - 4x4 @ 10 feet long
1 - sheet 1/2” plywood (could use a half sheet if you cut the pieces into two pieces, each 21” x 31 1/2” but you will have a seam down center of bottom shelf)
4 - 2x4 @ 8 feet long (cut 50” cuts first)
2 1/2” pocket hole screws
4” overall clearance caster wheels
2” flat headed screws or finish nails (for attaching bottom shelf)
4 - 4x4 @ 24 1/2”
4 - 2x4 @ 50”
4 - 2x4 @ 14”
3 - 2x4 @ 17”
1 - 1/2” plywood @ 21” x 57”
2 - 2x4 @ 9 1/2”
4 - 2x6 @ 59”
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
TIP: Drill 1 1/2” Pocket holes on insides of front/back aprons, facing upward, for attaching the top in later steps, prior to attaching aprons to legs.
TIP: If you don't have a right angle drill, you may wish to do the next step (step 7) first as you may run out of room for your drill to fit.
Followed by the front and back aprons.