Pub Table with cooler and logo's

Difficulty
Intermediate
| Print this plan

Liked the idea of the patio table with cooler but wanted something little smaller and taller as I building some high back pub chairs to match. I also really like Fireball Whiskey so decided to incorporate into the table. I am also planning on going by autozone as they have thin striped red led lighting that I am going to adhere to the planter box so when filled with ice it will look red. So cool!

inspired by the patio table with built in cooler on this site

48x48x36

Preparation

Shopping List

4- 2x4x8
2 - 4x4x8
3 - 2x6x8

scrap 2x8 @ 23 3/4

2 scrap 3/4" plwood 5" x 24

2 scrap 3/4" plywood 4" x 12"

kreg screws 2 1/2
kreg screws 1 1/4

Cut List

4 - 2x6 @ 35 3/4
2 - 2x6 @ 45 3/4
8 - 2x4 @ 23 3/4
4 - 4x4 @ 34 1/2
2 - 2x4 @ 36 3/4
2 - 2x4 @ 37 3/4

Cutting Instructions

to follow

Tools
Tape Measure
Speed Square
Pencil
Hammer
Kreg Jig
Drill
Miter Saw
Table Saw
Brad Nailer
Power Sander
Level
General Instructions

Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!

Finishing Instructions
Preparation Instructions
Fill all holes with wood filler and let dry. Apply additional coats of wood filler as needed. When wood filler is completely dry, sand the project in the direction of the wood grain with 120 grit sandpaper. Vacuum sanded project to remove sanding residue. Remove all sanding residue on work surfaces as well. Wipe project clean with damp cloth.

It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.