My heating bitlls in the winter are outrageous, and the trees on my property have been dropping limbs like nobody's business this spring and summer. Two problems, one solution: lots of fires this winter!
The problem is that stacking the fallen wood too close to the house encourages termites. Stacking it farther away on the property, though, will leave the wood waterlogged and rotten. Not to mention that it's unsightly to have a pile of firewood in your yard. Hence a firewood shed.
16 - 2"x3"x8' construction grade
1 - .5"x4'x8' roofing ply
4 - cinder-blocks or other sturdy base
3" Exterior grade screws (deck screws are fine)
8 - 2"x3" @ 2'
2 - 2"x3" @ 7'
2 - 2"x3" @ 6'
9 - 2"x3" @ 8'
2 - 2"x3" @ 2'6" (approx.)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Start by building the sides. Cut a 1x3 to six feet, giving the cut edge a 22.5* angle. Then cut a second 1x3 to seven feet, again giving the cut edge a 22.5* angle.
Next, cut a 2x3 to two feet, and fasten it to the two longer sticks, six inches up from the edge. Notice that the two foot 2x3 overhangs the shorter stick by 1.75" - the same as the width of a 2x3.
Finally, checking carefully for square, place a 2x3 on top of the longer sticks, connecting them flushly. Scribe the angle of the cut on 2x3, cut it, and then fasten it to the top.
Repeat the same process as step one to create the second side. REMEMBER that the 2x3s connecting the long sticks will need to be on the OPPOSITE SIDE in order to make mirror image frames.
Next, attach the two faces using uncut 2x3s. The rear 2x3 fastens to the overhang you left in steps 1 & 2. The front 2x3 goes just behind the long stick.
If you aren't building on-site, this is a good time to move your frame to its intended location. Place the long sticks on top of stable cinder-blocks or patio pavers to make a level base.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.