Recyle/Waste Cabinet

Submitted by RITWood on Sat, 10/07/2017 - 11:03

Keeping with the cottage farmhouse this is my take on the Wood Tilt Out Trash/Recyle cabinet.  I used construction grade 1x12's.  I would consider this project an intermediate level because I used two 2x12x8 and machined the smaller dimensional material.  I rounded over the faces using a 3/8 inch round over bit in my router.  Multiple coats of sprayed on latex followed by several light coats of water based poly.  

Estimated Cost
Estimated Time Investment
Day Project (6-9 Hours)
Type of Wood
Construction grade pine
Finish Used
Fireweed red latex with a clear coat of polycrylic. I used a HVLP sprayer to apply the finish. It takes several light coats of the red to cover adequately. Smooth moderate sweeping motions work the best.
Recommended Skill Level

Free Plans Made Possible By Our Sponsors