Christmas Tree

Submitted by AndyH on Wed, 12/10/2014 - 08:31

Simple Christmas Tree made from 3/4 inch and 1/2 inch square dowels, a bit of scrap 2 by 2 and some scrap 2 by 6.

The dowels were drilled and a metal rod inserted through them all.  Two nuts at top and bottom tightened once the dowels were arranged in place.

Each dowel was cut 0.5 inches shorter than the previous one so it was 1/4 inch sorted on each end.

Each dowel was placed 45 degrees from the one below it.

 

Pin For Later! 

Christmas Tree

 

Estimated Cost
$15 for dowels. Base was from scraps left and paint was left over from another project.
Estimated Time Investment
Afternoon Project (3-6 Hours)
Finish Used
White paint.
Recommended Skill Level
Starter Project

Comments