3 - 2 x 4 studs
6 - 2 x 2 x 8
1 - 1 x 4 x 8 (furring strip)
1 - 1 x 2 x 8 (furring strip)
1 - 1 x 3 x 8 (furring strip)
2 - 2x4 @ 35" (backs - cut backs from these)
2 - 2x2 @ 23 1/4"
2 - 2x2 @ 16"
2 - 2x4 @ 16"
2 - 2x2 @ 16 3/4" (longest point measurement, one end cut at 6 degrees off square)
3 - 2x4 @ 37"
2 - 2x2 @ 37"
4 - 2x2 @ 12 1/2"
2 - 2x2 @ 17 5/8" (ends cut to 45 degree points, longest point measurement)
4 - 2x2 @ 8 1/8" (one end cut to 45 degree point, longest point measurement)
8 - 2x2 @ 6 1/4" (longest point measurement, one end cut at 45 degrees off square)
8 - 2x2 @ 3 5/8" (longest point measurement, one end cut at 45 degrees off square)
4 - 1x4 @ 40"
1 - 1x2 @ 37"
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Start by cutting the back legs out. I recommed cutting the long straight cuts with a circular saw, and then finishing the cuts with a handsaw or jigsaw, but you could make the entire cuts with a jigsaw as well. Just make sure you have the right blade, it's sharp, and you go slow and sand the cut edge well.
You'll need to cut two. Make sure you mark the boards as shown in diagram before cutting.
Next, add to the back legs the front legs, seat support, arm rest support and bottom stretcher. Make two and make sure they match. Easiest way is 1 1/2" pocket holes and 2 1/2" pocket hole screws and glue but countersunk screws could work too. If using pocket holes, try hiding on underside whenever possible to prevent water pooling in your pocket holes.
Free plans to build a woven back bench from Ana-White.com
Once you have the two legs done, join together with 2x4s. With the bench frame complete, let's set aside and work on the back.
I'd lay all the boards out first just to make sure everything fits. And then start assembling. For a painted finish, pocket holes on the back sides will work great.
TIP: Hide pocket holes on insides of the 2x2s - will get covered up in next step.
Fit your Xs and attach.
And then make up 8 of these little Y guys and attach in place. These are more decorative than anything, so a good outdoor glue could even be used to secure.
And then attach to back.
If you used pocket holes, I highly recommend filling any exposed holes with plugs.
Attach bottom stretcher to base.
And finally, add the seat slats on top.
These can be attached from underside with 2" screws and glue to hide screw holes.
Don't forget the arm rests! You can attach these from the underside with 2" screws and glue to hide any holes.