Baby Nova's Changing Table

My son and his girlfriend are expecting baby Nova in May.  He asked that I build her a changing table or a toy box.  I picked the the table.

The drawer setup in the plans is not clear, however I used 14" drawer slides.  I mounted a small 1x2 on each side and in the middle to mount the drawer slides to.  To accomodate the drawer slides, I had to reduce the width of the drawers by approximately 1/4 inch.  I waited until the I was ready to install the drawers so could fit check them prior to final cut and drawer slide installation.

As for the Baskets underneath - they are Elfa baskets from the Container Store.  They are mounted in with slide out trays.

Estimated Cost
$400 - the Elfa baskets were 1/2 the cost.
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
Valspar Signature Latex Semi-Gloss Ultra White
Recommended Skill Level
Intermediate