Outdoor Lounge Chair

Submitted by Goldy272 on Mon, 05/19/2014 - 09:44

Simple outdoor lounge chair for use on our deck. This is a good design though if I had to do it over again I would make a few alterations:

- It's a bit flimsy, so for the chair frame, I would use 2x4's instead of 1x's.
- We are going to use them for seating at our patio table so I will make the others a bit shorter. The depth is awfully big for a dining chair but would be good for lounging.
- Used a 1x4 on the inside of the back frame to make the chair back more upright (as it said in the modified plans) would definately recomend.

Built from Plan(s)
Estimated Cost
$25
Estimated Time Investment
Afternoon Project (3-6 Hours)
Finish Used
None yet.
Recommended Skill Level
Intermediate