Platform Bed and Headboard

Submitted by ScottG on Tue, 01/26/2016 - 01:24

Built a platform bed and headboard using 2x4s for the main frame and 1x4s for the trim pieces on the bed. The headboard was made using 1x6s for the frame and 1x4 scrap pices from the slats used for the vertical pieces. Used a Minwax water-based "pearl gray" stain for the 1x8 sides and a Minwax oil-based walnut stain for the frame and trim pieces. Used the K5 Kreg jig to join most of the pieces. The Kre Jig was a new purchase and my advice would be to practice with the jig before starting the project. It takes awhile to get the hang of the jig and to make sure that you are using the correct screw lengths. The very complete and detailed plans can be found in the attached links.

Built from Plan(s)
Estimated Cost
Wood cost was about $100 and this would include the 2x4 for the frame, the 1x4 furring strips for the slats and headboard, and the 1x4 and 1x6 trim and frame boards. The stain and polycrylic sealer cost about $20. You should also budget for Kreg screws, wood glue, nails, etc. I did have to buy several clamp, and the Kreg Jig cost a bit, but is well worth it. I've used the the clamps and the jig on many projects since the original purchase.
Estimated Time Investment
Week Long Project (20 Hours or More)
Type of Wood
2x4 Fir and Pine Boards
Finish Used
Minwax water based and oil-based stains and Polycrylic water-based sealer. .
Recommended Skill Level

Free Plans Made Possible By Our Sponsors