Submitted by Anonymous (not verified) on Sat, 05/13/2017 - 07:07

A full write up of this build, including photos & dimensions, is here: http://imgur.com/gallery/YyawW

Built from Plan(s)
Estimated Cost
The wood cost $40.
The Kreg K5 pocket hole jig cost ~$130.
The stain & polyurethane cost ~$15 total.
The lag bolts + washers + nuts cost ~$10 total.
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
1) Sand all individual pieces (prior to assembly) by hand. I believe I used only 60 grit sand paper, because I wanted to retain the look of lumber.
2) Varathane brand stain; color "Early American." Applied with a rag, not a brush.
3) Varathane brand Triple Thick Polyurethane; satin finish. Applied with a rag, not a brush. Polyurethane applied to the 2x6 table top surface boards only (i.e. I did not apply polyurethane to the table's skirt or to the table's legs).
4) Lightly sand the dried polyurethane by hand with 300 grit sand paper to obtain a smooth-to-the-touch surface finish.
Recommended Skill Level
Beginner