transitional bath room vanity

Submitted by Texalyn on Tue, 03/31/2015 - 07:14

I changed the height of the Connor Side Table to that of a bathroom vanity and added an apron to hide the underside of the sink.  I carefully built the vanity to be level, then discovered that the underside of the sink surround is wavy (apparently they are made by being poured into an upside down mold, hence the wavy surface).  I added trim at the top of the vanity to hide the shims stabilizing the sink top.  Thx to Rogue Engineer for the well-written plans, and thx to Ana White for your Kreg pocket hole jig video.  It made me feel confident I could pull this off!

Built from Plan(s)
Estimated Cost
Estimated Time Investment
Weekend Project (10-20 Hours)
Type of Wood
red oak
Finish Used
MinWax Golden Oak stain, two coats of MinWax Clear Satin Polyurethane, with light sanding with fine sandpaper between coats
Recommended Skill Level


Free Plans Made Possible By Our Sponsors