A bridge over your media station can give your storage a built in look and quality. But bridges can often be very expensive and not fit just right. With this simple plan that works with the rest of the Classic Media Storage Collection, you can build your own bridge, fit just perfect for your own tv, without spending a bundle.
1/2 Sheet of 3/4″ MDF or Plywood, cut into 16 1/2″ Strips, 8′ long
3 – 1×2
1- 1×3 (you will only need 60″)
at least 62″ of 2 1/2″ high moulding
A) 2 – 1×16 @ 13 1/4” (Sides)
B) 1- 1×16 @ 62” (Top)
C) 1 – 1×16 @ 60 1/2″ (Bottom)
D) 1 – 1×16 @ 12 1/2″ (Centers)
E) 4 – 1×2 @ 14″ (Side Trim)
E) 1 – 1×3 @ 59″ (Front Top Trim)
F) 3 – 1×2 @ 59″ (Back Top and Bottom Trim)
Crown Moulding, 2 1/2″ overall height, 62″ Long
Cut your 3/4″ Plywood or MDF into strips 15 1/2″ wide by 8′ long. These strips become 1×16 boards. Make your longer cuts first, and then your shorter cuts from the scraps.
Work on a clean level surface. You can fasten with nails or screws, depending on your tools and the use of this piece. Screws will hold better, nails are easier. My general rule is screw anything that will be “used” like chairs and benches, and nail sedentary pieces like bookcases and hutches. I will leave this up to you. If you are screwing, make sure you predrill and countersink your screws. If you are using MDF, avoid fastening within 1″ of the edge of the MDF. Do not use wood screws on MDF. Wood screws do not have a straight shaft and will split your MDF. I have had luck with drywall screws (after all, drywall is very similar to MDF). Make sure you predrill the entire distance of the screws. It’s going to screeech, so wear hearing protection. And glue, glue, glue.
My favorite option is to screw the “box” together, and then use finish nails to add the frame. That way the frame does not have blemishes, but the piece is built sturdy.
Make sure you take a square of the project after each step. Measure and mark out any joints before fastening. Be safe, have fun.
Wood Composition. The above diagram shows the composition of the different pieces. The “box” is made of 3/4″ plywood or MDF, the trim is mostly 1x2s and a 1×3 boards (pine or MDF for paint grade, hardwood to match A1 plywood for staining). The crown moulding can also be MDF or pine for painting, but should match the A1 plywood for staining.