This mudroom is DIY and I spent less than $150 on it! Check out the full tutorial, you will be amazed at how easy it is to build yourself!
We are very thankful to Columbia Forest Products for providing beautiful and healthy PureBond Plywood for this project. The cost of $148 reflects an average price of $48 a sheet of PureBond Plywood. For those of you who cannot find PureBond Plywood at your local Home Depot, ask the manager of the store to start carrying it. It is comparable in cost to other hardwood plywoods, but a healthier alternative. And in the meantime, visit the PureBond website for other distributors and resellers.
2 - Full Sheets 3/4" thick PureBond Plywood (available at the Home Depot) cut into strips 15 1/2" long and 8 feet long, referred to as 1x16 boards in this plan.
TOP SHELF CUT LIST
2 - 1x16 @ 72"
4 - 1x16 @ 16"
1 - 1x3 @ 72"
1 - 1x2 @ 72"
4 - 1x2 @ 13 1/2"
1 - Crown Moulding Strip @ 72"
2 - 1x3 @ 23 1/8" (Sides - Optional if need to support shelf from back)
1 - 1x3 @ 22 3/4" (Center - Optional if need to support shelf from back)
BENCH CUT LIST
1 - 1x16 @ 72"
4 - 1x16 @ 17 1/4"
1 - 1x3 @ 72"
4 - 1x2 @ 15 1/2"
1 - Edge Moulding Strip @ 72"
CENTER CUT LIST
2 - 1x16 @ 47 7/8"
2 - 1x3 @ 23 7/8" (cut to fit)
1 - 1x3 @ 22 3/4" (cut to fit)
2 - 1x3 @ 14 3/4" (Optional sides for extra hooks)
Have the Home Depot cut your PureBond plywood into 15 1/2" wide strips, 8 feet long. The strips will be easier to transport and cut. These strips will be referred to as 1x16 boards throughout the plan.
Make sure you measure your mudroom carefully and are certain you can move the piece in. Mine was so tight of a fit, we had to remove moulding to get it in place.
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Build the box. This is the basic frame for the upper shelf. It will be fully framed, so nailgun lovers, nail away. I used Kreg Jig pocket holes, but you can also use 2" screws or nails - just adjust for square and use glue.
Make sure your upper shelf is well supported, screwed to at least two studs in the wall at minimum, on each end. If you used a freestanding design (no side walls) you MUST add blocking as shown above and screw through the blocking.
Attach the hook blocking as well. I used pocket holes to attach, and also nails and glue into the wall.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.