Free plans to build a barn shaped bookshelf - perfect for your farm themed children's room! Our step by step plans include diagrams, shopping and cut list, and lots of reader submitted photos.
- 3 - 1x12 @ 8 feet long
- 2 - 1x2 @ 8 feet long
- 6" of 1x6 scraps
- 1/2 sheet of 1/4" plywood for back
- 4 - 1x12 @ 27” (shelves and sides)
- 1 - 1x12 @ 12” (divider)
- 1 - 1x12 @ 28 1/2” - both ends BEVELED at 22 1/2 degrees off square, long point to long point, ends NOT parallel (middle floor)
- 1 - 1x2 @ 27" (footer)
- 2 - 1x12 @ 16 1/4” - both ends beveled at 22 1/2 degrees off square, long point to long point, ends NOT parallel (lower roof)
- 1 - 1x12 @ 18” - both ends beveled at 22 1/2 degrees off square, long point to long point, ends NOT parallel (loft floor)
- 2 - 1x12 @ 10” - both ends beveled at 22 1/2 degrees off square, long point to long point, ends NOT parallel (upper roof)
- 2 - 1x6 @ 2 1/4” long point, cut at 22 1/2 degrees off square (optional loft siding)
- Back plywood is 45” x 28 1/2” overall.
- FENCE 2 - 1x2 @ 27" 4 - 1x2 @ 6 3/4"
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Start by building the bookshelf base. You can use 2" countersunk screws and glue or 3/4" PHs/1 1/4" PH screws and glue, but nails are not recommended because there is no face frame.
TIP: If using PHs you may wish to add the top (step 2) first to fit the drill in there, and then add middle shelf second.
Now add the top.
Now add the divider. You can just nail or screw this guy in.
And the footer - glue and nails will do the trick here.
Now add the loft floor. Easiest way is 3/4" PHs and 1 1/4" PH screws from underside.
Glue and nail the remaining roof pieces in place. The next pieces will strengthen everything up.
Add the roof pieces to secure top roof. Use glue and finish nails.
Finally, add the back to the entire project with 1 1/4" finish nails and glue.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.