2x4 Adirondack Chair Revised

Submitted by Katruax on Fri, 07/10/2020 - 16:49

Love the plan Ana! I made a couple slight revisions and made mine out of all 2x material. I used 2x6 for the arms with a taper and extended the arms over the front leg by 1.5 inches and used 2x6 and 2x4 for the seat and back slats. Boys it sits great! One other thing I did is I used pocket holes and concealed all my fasteners so I don't have any screws showing.

Estimated Time Investment
An Hour or Two (0-2 Hours)
Recommended Skill Level
Intermediate

Comments

HR Dad

Mon, 10/19/2020 - 13:58

Great job. I too have prepped 2x6 for the arms, also with a taper, but only a 1" overhang on front. Appreciate the pics. I've made all my cuts but was starting to get concerned that the larger dimension arms would look funny. I also considered doing the stretchers as 2x6. Your pics make me rest easy that they'll look fine. Also using pocket holes where possible. Good stuff!
Cheers!