![](/sites/default/files/diy%20printer%20stand.jpeg)
I adapted the plan to make a stand for our printer and shredder. Except for one board, I was able to use scraps so my total out of pocket was $9! I did plane the 2x material to 1 1/4”, and also used 2x material for the base to add a little strength to hold the shredder. Thank you Ana White, for generously sharing your plans!
![](/sites/default/files/2483350D-662E-40E9-BB89-34DC9D4C7AC2.jpeg)
![](/sites/default/files/printer%20stand.jpeg)
Built from Plan(s)
Estimated Cost
$9
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
Top - mixed brown and gray rustoleum stains. Finished with poly acrylic
Base - latex eggshell trim paint (custom mix leftover)
Base - latex eggshell trim paint (custom mix leftover)
Recommended Skill Level
Intermediate