Industrial Numbered Crate

Submitted by efmolly on Thu, 04/25/2013 - 22:51

I built this storage crate to fill out space on top of my kitchen table. On my table saw, I ripped 1/2in birch plywood down to 6in widths for the outside frame and 5 3/4in for the dividers. The dividers are 6in wide and so I cut the outside ends to 7in. I attached the whole thing with 1 1/2 finish nails and glue. After finishing, I attached some L-brackets on the corners and drilled 2 holes on either end for handles. For handles, I simply braided 6 strands of jute together and tied knots on the inside of the box. I have more details and photos on my blog link.

Estimated Cost
$20
Estimated Time Investment
An Hour or Two (0-2 Hours)
Finish Used
I started by staining the whole thing with Antique Walnut by Minwax. I then used Antique Crackle medium by Old Fashioned Milk Paint, and used some Vaseline for paint resistance on the edges. I then applied one coat of a creamy white, latex paint. After stenciling the numbers, I sealed the entire piece with Crystal Clear by Krylon in matte.
Recommended Skill Level
Beginner

Comments