Ladybug chair

Submitted by Anonymous (not verified) on Thu, 04/21/2016 - 03:18

This was a true joy to build. I plan on making at least three to four more of these. Couple tips I learned though: I used pocket hole screw where I could to prevent drilling so many holes that would need to be filled: Ft board, Rear boards, and a couple others. Also I routed the edge of the very front board where the child's legs will be dangling from, as well as the inside/outside edges of the arm rests. Smoother the better I thought with little kids. Lastly, I painted all the boards and then put it together as recommended. However, I would go through the plans and only paint the surfaces that you know will either touch and will be difficult to get to or sides that won't be drilled out; unless you don't plan on filling the holes and painting over them. It will save you paint and time if you plan out what sides of what boards you'll paint first than doing them all at once.

Built from Plan(s)
Estimated Cost
~$35
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
Exterior latex paint
Recommended Skill Level
Intermediate