Submitted by Ball on Tue, 06/28/2016 - 08:26

The bed is a mixutre of the loft bed plan and the farmhouse loft bed plan with some modifications of my own thrown in.  I liked the headboard look of the farmhouse loft bed and incorporated it into the plan.  I also made the side rails out of 1x10's to make it more beefy looking and I think it works better.  The supports for the mattress are made out of 3/4" bookshelves, cut down to fit as it added more support than 1/2's.  The desk is based off the loft bed desk plan, but I made the top piece out of 3/4" MDF. I think it makes a nicer look.  I added 1x2's to the face of the bookcases and desk top to finish it off and make everything look more finished.

I also added a programmable, remote controlled, RBG LED lighting system under the bed.  My daughter can go from dance party to mood lighting depending on the situation.  This bed will deliver.

I also modeled everything in 3D CAD using Solid Edge.  This was a very helpful tool to get all the measurements correct as well as incorporating 3 different deisigns blended with my own.

 

Estimated Cost
$300
Estimated Time Investment
Week Long Project (20 Hours or More)
Finish Used
Sherwin Williams Pro-Classic acrylic latex enamel.
Recommended Skill Level
Intermediate