![](/sites/default/files/Photo%20Nov%2029%2C%202%2053%2046%20PM_0.jpg)
Took about 1 week to finish the project. I like the overall result.
Instead of using pocket hole to join the top, I use dowel and glue to join the board together. Clamp the top in sections then combine 2 large piece together.
using the speed squre to create the 45 degree angle and use the circular saw to cut out the angled section.
I used the table saw to cut off the round edge on 2x2 to create smooth Table apron.
Use wood filer to fill all the crack and hole from brad nail/joint.
apply 2 layer of stain. allow it to dry overnight. Then Thin out poly with minaral Spirit to wipe on 4-5 layers.
sand finish in between with 330 grit paper
![](/sites/default/files/Photo%20Nov%2008%2C%204%2052%2039%20PM.jpg)
![](/sites/default/files/Photo%20Nov%2009%2C%203%2025%2017%20PM.jpg)
![](/sites/default/files/Photo%20Nov%2029%2C%202%2053%2046%20PM.jpg)
![](/sites/default/files/Photo%20Nov%2029%2C%202%2053%2053%20PM.jpg)
![](/sites/default/files/Photo%20Nov%2030%2C%206%2044%2045%20PM.jpg)
Built from Plan(s)
Estimated Cost
300
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
Min-wax Red Mahogany with 4 layer of Min-wax polyurethane
Recommended Skill Level
Intermediate