This project could take alot less time if I had a wood planer. I use a belt sander to sand all pallet wood and this is what takes the longest. Well applying the polyurethane takes a while to finally get it to the way I like it. Bc I'm my worst critic.
Estimated Cost
Cost on 30.00 or less depending if you have all material already. All you need to purchase is screws
Estimated Time Investment
Week Long Project (20 Hours or More)
Finish Used
Stain of choice and polyurethane.
Recommended Skill Level
Beginner
Comments
Malka
Wed, 03/30/2016 - 00:19
Seriously too awesome
This is probably the coolest brag I've seen on here! Do you think this is something a beginner could pull off with a coping saw? I'm assuming you cut the state out, stain the rest of the board, and then glue/screw it all back together? Seriously this is amazing, kudos to you!
In reply to Seriously too awesome by Malka
Joep_erez
Wed, 09/07/2016 - 00:43
Thanks
Actuall all i did was put duck takp to try to keep stain from leaking under. When i got close to stain I just patted it slowly and that was final result. But thanks for comment.