I recently saw a similar tray on Pinterest and decided to come up with my own version. It's approximately 20 x 12 3/4" and is made from a scrap 1x12 and 1x4s. The removable insert fits 3 pint mason jars for holding silverware and 18oz plastic cups. The handles were purchased from Hobby Lobby.
Tray cut list:
1x12 cut to 18"
2 1x4s @ 11 1/4" (cut to fit short sides)
2 1x4s @ 20" (cut to fit)
- glue and nailed with 1 1/4" brad nails
Removable Insert cut list:
2 1x4s @ 8 1/4" (sides)
1 1x4 @ 12" (top)
1 1x4 (divider) cut to fit, a little less than 10 1/2" (center divider is positioned 3 1/2" from bottom opening)
Glued and nailed with 1 1/4" brad nails
Estimated Cost
$10
Estimated Time Investment
An Hour or Two (0-2 Hours)
Finish Used
Rustoleum matte black spray paint and 2 coats of satin wipe on polyurethane
Recommended Skill Level
Beginner