I built this for a friend who needed a small side table. All the cuts were made with a chop saw. I used 1X3 furring strips and 2X2's. It was a little tricky to get all the table slats to match up. I used the Kreg jig to conceal all the screws and get stronger joints. I love that thing!
Built from Plan(s)
Estimated Cost
$10
Estimated Time Investment
Afternoon Project (3-6 Hours)
Finish Used
I brushed on two coats of Minwax Polyshades in Honey Pine Gloss, then rubbed in a coat of Howard Feed-N-Wax.
Recommended Skill Level
Beginner