Needed a two seat bench for an existing table. Used biscuits instead of pocket screws to manufacture the seating surface. Cut 1/4" from each edge of the 2x4 (original 1.5" x 3.5" => now 1.5" x 3.0") so the premilled humps would not be evident on the seating surface. The surface now has 6 layers of boards for 6x3=18" width instead of the plans 5x3.5 = 17.5" Great plans, easy to modify!
Built from Plan(s)
Estimated Time Investment
Weekend Project (10-20 Hours)
Finish Used
Will be stained to match rest of table later
Recommended Skill Level
Intermediate