Craftsman Style Playhouse

Submitted by Ana White on Sun, 05/16/2021 - 12:41
| Print this plan

This gorgeous playhouse features wide open french doors, a taller ceiling, and beautiful windows.  You'll love the step by step plans and diagrams.  Beautiful reader submitted photos by AerialC

beautiful cedar playhouse

We love this playhouse because it is tall inside, so big kids and Mom's under 6 feet can play too.  

We love that the windows add natural light.  

We love that both doors open up and it feels so giant in there!

And we love how simple this playhouse was to build.  Read on - once you get the four walls built on the ground, you just stand them, tie in with some roof rafters, and put plywood on top.  It really is pretty simple!

PS - The deck plans are here.

dimensions for playhouse
Dimensions shown above


Shopping List

5 - sheets exterior plywood (we used 3/8" but see notes on roofing plywood below)

8 - 2x2 @ 8 feet long

20 - 2x4 @ 8 feet long

1x3s for doors if desired

2-1/2" pocket hole screws (blue coated exterior ones)

Galvanized nails or screws for attaching plywood

Roofing of choice

Cut List

Listed in steps

Tape Measure
Speed Square
Safety Glasses
Hearing Protection
Kreg Jig
Circular Saw
Miter Saw
Brad Nailer
General Instructions

Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!


Step 1


  • 2 – 2x4 @ 63 1/2" (top cut at 30 degrees off square)
  • 2 – 2x4 @ 50” (top cut at 30 degrees off square)
  • 2 – 2x4 @ 59 3/8” (top cut at 30 degrees off square)
  • 4 – 2x4 @ 18 3/4"
  • 2 – 2x4 @ 22 1/4"
  • 1 – 2x4 @ 44 1/2"


  • 2 – 2x2 @ 15 1/2"
  • 4 – 2x2 @ 8 5/8”
  • 4 – 2x2 @ 10”
  • 2 – 2x2 @ 18” (top end cut at 30 degrees off square)
  • 1 – 2x2 @ 24 1/4" (top dogeared to 30 degrees off square) - this is the top center piece

The entire front wall was built on the ground with a Kreg Jig set for 1-1/2" stock and using 2-1/2" pocket hole screws.

The 2x4 boards are joined together flat (so the wall is 1-1/2" thick before plywood).

Wait until after you build the other walls to use scrap plywood for filling in the blue pieces.

We used 3/8" exterior plywood, just nailed on from back.

Top rafters overhang the outer 2x4s by 6", measured along bottom edge of rafters.

Step 2



  • 2 – 2x4 @ 63 1/2” – one end cut at 30 degrees off square
  • 2 – 2x4 @ 50” – one end cut at 30 degrees off square
  • 2 – 2x4 @ 59 3/8” – one end cut at 30 degrees off square
  • 1 – 2x4 @ 62 1/4” – top dogeared to point at 30 degrees off square
  • 1 – 2x4 @ 89” 2 - 3/8" exterior plywood 48" cut to fit - save scraps for the front wall.

We built the back wall again on the ground, using the Kreg Jig again. The blue is 3/8" exterior plywood nailed on to back. Again, 2x4 boards are joined together flat, so wall is 1-1/2" thick before plywood is attached.

Step 3


  • 12 – 2x2 @ 45”
  • 2 – 1/2" plywood @ 45” x 48”

Build two of the side walls - we used the Kreg Jig here too.

Step 4

Once all the walls were built, we attached the front and back walls to the side walls to create the walls of the playhouse. Then we added rafters to make the roof.


  • 10 – 2x4 @ 45”

Step 5

Attach roof plywood to top.  

Step 6

DOORS - BUILD TO YOUR OPENINGS.  We recommend leaving generous gaps around the doors to prevent finger pinching. 

  • 4 – 1x3 @ 48”
  • 6 – 1x3 @ 17”
  • 2- ½” plywood @ 22 ¼” x 48”

We built the doors out of 1x3s and added the 3/8" plywood to the back. If your roof plywood is 3/4" thick, you could just use the slabs as doors. Also, later on we ended up trimming 2" off the bottoms of the doors just so they open easy and no toes get scraped underneath the door.

Finishing Instructions
Preparation Instructions
Fill all holes with wood filler and let dry. Apply additional coats of wood filler as needed. When wood filler is completely dry, sand the project in the direction of the wood grain with 120 grit sandpaper. Vacuum sanded project to remove sanding residue. Remove all sanding residue on work surfaces as well. Wipe project clean with damp cloth.

It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.



Sun, 07/11/2021 - 13:37

With that said, this knife will not compete with fine offerings from brands like Yoshihiro, Shun, or even Dalstrong. Our detailed Tojiro Knives Review will focus on both the upsides and downsides of choosing a Tojiro DP knife over an option from another brand. You’ll learn everything that you need to know in order to decide whether or not a Tojiro chef’s knife is right for your kitchen.


Mon, 07/12/2021 - 08:54

Mati Marroni is a US Internet personality that is famous for publishing semi-naked photos on Instagram. She is also the viral girl who rose in prominence for having a Whataburger hamburger.


Thu, 07/15/2021 - 07:49

An online incorporation services is a provider that can help register your business. This often means incorporating the business as an S or C corporation or forming an LLC. By doing this, the owner or owners of a company can form a legal entity to conduct business.


Sat, 07/17/2021 - 23:49 specializes in LLC formations and promises a quick turnaround time. BetterLegal provides one streamlined option that includes the most commonly requested documents/services (no upselling or advertisements). BetterLegal was founded in 2016 and is headquartered in Austin, Texas. Read our complete BetterLegal reviews.


Sun, 07/18/2021 - 07:46

You’ll get the street address in the state of Texas that you need, scan every document that they receive on your behalf and then forward them to you (they are the only registered agent in Texas on this list to do so with EVERY piece of mail received), and give you an online account in order to access every document as well. Read more to find best registered agents in Texas.

Free Plans Made Possible By Our Sponsors