A simple, inexpensive outdoor table with modern styling that you can build in an afternoon. Seats four and features a slatted top and bottom stretcher.
5 - 1x3 Boards, 8 feet long
5 - 2x2, 8 feet long
2 1/2" screws or 2 1/2" pocket hole screws
7 - 2x2 @ 24 1/2" (Ends/Supports)
3 - 2x2 @ 44 3/4" (Sides/Stretcher)
4 - 2x2 @ 29 1/4" (Legs)
10 - 1x3 @ 47 3/4" (Decking)
From the 2x2s, cut one 2x2 @ 44 3/4" and two 2x2 @ 24 1/2" from three of the 2x2s to conserve lumber.
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Begin by building your tabletop frame as shown above. Mark the placement of all joints and either use the Kreg Jig to drill pocket holes or a countersink bit to drill holes from the outside. Attach with 2 1/2" screws and wood glue.
Now the legs . . . build two of these in the same manner as the tabletop. If you are using the Kreg Jig, remember to keep your pocket holes to the bottom, as water could pool in exposed pocket holes, and potentially destroy your table.
Now simply attach the tabletop frame to the legs. I just turned the whole thing upside down and got my drill out :) Use glue and 2 1/2" screws.
The stretcher really helps to keep the base square, and to keep the legs stable. Center the stretcher on the end boards and attach with screws and glue. Check out the dimensions diagram for center measurements - it's 12 7/8" from the outsides.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.
We primed and sprayed High Gloss Enamel Ultra Pure White by Valspar on, two coats. If you do not have a sprayer, you may consider painting your boards - decking especially - before assembly, as it is very difficult to get a pretty paint job on a slatted design such as this.
We apologize if there was an error in this plan. Please help us out and report any errors here.