Make your own wood magazine files with bookplates and decorative faces for $2.50 each! These quick and easy magazine files will create order and style in your home!
UPDATE: When I figured the 18 magazine files per sheet of 1/4" plywood, this was assuming a 45 degree angle on the sides. But I choose a 30 degree angle because it is easier to cut with a standard sliding 10" mitersaw. With a 30 degree angle, you will only be able to make 15 magazine files from a sheet of 1/4" plywood. If you would like to maximize the number of magazine files you can make, cut the ends at a 45 degree angle, longest point 12".
1/4" plywood (for 9, use 1/2 sheet - for 18, use full sheet)
1x4 @ 8 feet long - 1 for 9, 2 for 18
Glue (Gorilla glue would be great here)
1 1/4" finish nails
Book Plates and fasteners
Scrapbooking Paper (3 sheets for 9, 6 sheets for 18)
2 - 10" strips @ 12" long, one end cut at 30 degrees off square, longest point measurement (see diagrams in step 2)
1 - 1x4 @ 10" (bottom)
1 - 4" strip @ 12"
1 - 4" strip @ 6 1/4"
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Have your hardware store cut your plywood into strips as shown in the diagram. Otherwise cut your plywood with a tablesaw into strips as shown in the diagram.
By cutting into strips, you can be sure that the plywood grain is all in the right direction, and your wood pieces are consistently the same width.
When you are finished cutting the pieces, nail the sides to the bottom as shown above with glue and 1 1/4" nails.
Once both sides are on, attach the front. You can only nail to the 1x bottom board. Glue the sides and tape with the painter's tape, getting the tightest possible joint.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.