![desktop organizer](/sites/default/files/diy-wood-desk-vanity-organizer-office-beauty-pine-wood-3.jpg)
Use scrap wood to build a desktop or vanity organizer with cubbies and a drawer!
![desktop organizer plan](/sites/default/files/images/beauty%20hair%20organizer%20diy%20wood%20dimensions.jpg)
Preparation
34" of 1x10
45" of 1x3
18" of 1x6
14" of 1x4
1/4" plywood scraps 8-1/2" x 13-1/4" and 15" x 10"
1 - 1x10 @ 13-1/2" (middle shelf)
1 - 1x3 @ 13-1/2" (front trim)
1 - 1x6 @ 13-1/2" (center divider)
2 - 1x10 @ 10" (sides)
2 - 1x6 @ 4-1/4" (angled dividers cut down in later steps)
1 - 1/4" plywood @ 15" x 10" (back)
2 - 1x3 @ 8-1/2" (drawer sides)
1 - 1x3 @ 11-3/4" (drawer back)
1 - 1/4" plywood @ 8-1/2" x 13-1/4" (drawer bottom)
1 - 1x4 @ 13-1/4" (drawer front)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Instructions
Step 3
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.
Comments
xbcraunx
Sat, 12/30/2017 - 17:21
Depth dimension discrepancy in plan diagrams
In the first diagram, the depth of the right-side organizer side panel is labeled as 9-1/2" while every other subsequent diagram specifies a depth of 9-1/4" for the organizer. I assume it's the latter, but just want to confirm and save myself a headache. Thanks.
xbcraunx
Sat, 12/30/2017 - 17:27
Depth dimension discrepancy in diagrams
The first diagram showing the depth (i.e. front-to-back) of the organizer's side panels is labeled as 9-1/2", while every other diagram shows the depth dimension as 9-1/4". I assume it's the latter, but want to save myself a headache. Thanks.