Build your own rustic bookshelf with our free plans. Features four large shelves and x detailing on the ends. Step by step plans from Ana White
- 8 - 2x2 @ 8 feet long
- 4 - 1x12 @ 6 feet long
- 4 - 2x4 @ 8 feet long or stud length
- 1 - 2x6 @ 12 feet long (can be cut down to 8 feet for transport)
- 4 - 2x4 @ 68"
- 10 - 2x2 @ 35-1/2"
- 6 - 2x4 @ 11-1/4" - matches width of 1x12s
- 4 - 2x2 @ 11-1/4" - matches width of 1x12s
- 4 - 1x12 @ 35-1/2"
- 3 - 2x6 @ 45"
- 2x2 X detailing should be cut to fit
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
TIP: You may wish to drill all the 3/4" pocket holes on the 1x12s in step 3 first, then set your Kreg Jig to the 1-1/2" setting for all remaining pocket holes, so you don't have to reset your Kreg Jig.
Drill a pocket hole on each end of the 2x2 @ 36" on the 1-1/2" setting.
Attach to 2x4 legs, clamping while you join, with 2-1/2" pocket hole screws and wood glue.
Build two identical frames.
The best way to do the Xs is place 2x2s alongside where you want them to go, and trace the angles, and then cut the angles with a circular saw.
I recommend attaching the shorter X pieces to the longer X piece before attaching the entire X inside the bookshelf.
To see how I do this, you can watch this video.
Lay the 2x6s on top of the bookshelf, with even overhangs on all sides.
Mark where the 2x6s cross the top 2x4 on your shelf ends.
Remove and attach the 2x6s together, inside where you marked, so the pocket holes will be hidden. Apply glue all the way down the joint.
Attach the entire top to the top of your bookshelf with 2-1/2" screws (you can use pocket hole screws, but they are more expensive than regular self tapping wood screws)
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.