Garage Sliding Screen Doors

Inspired by your diy barn door hardware, I wanted to create a way to have airflow in my garage as I work in there without the nuisance of bees, flies, and hummingbirds entering in. Since this is my first attempt to make a project like this, a few mistakes were made along the way, but, overall, I am happy to say my objective has been accomplished! Thank you, Ana, for inspiring me to start and finish this project to the end!DI

Estimated Cost
$250
Recommended Skill Level
Intermediate

Comments

eegad1973

Thu, 02/16/2023 - 12:52

Amazing, can you tell me what thickness your flat bar was and what size Fender washers you used. I am wanting make hardware for a door that is 27.5 inches wide by around 68 inches high. It is 1.5 inches thick. So I’m also curious what size bolts you used as I want to ensure 1/4inch bolts are enough. I’m struggling to find 2 inch diameter fender washers that have a 1/4 inch hole. I’m excited to make the hardware as traditional hardware is too big for the space. Any ideas are appreciated.

Email Me
Free Plans

Get new plans sent right to your inbox for free!

    We won't send you spam. Unsubscribe at any time.