Folding, compact plant stand perfect for putting your plants in their best light. Features folding design, so you can stash in the shed for winter, two slatted shelves, and modern styling. Inspired by Crate and Barrel Mendocino Folding Plant Stand.
Preparation
8 2" 1/4 diameter bolts
24" washer to fit bolts
8 nuts to fit bolts
6 - 1x2 boards, 8 feet long
4 - 1x2 @ 27 11/16" (Both ends cut at 30 degrees off square, ends are parallel)
9 - 1x2 @ 26"
2 - 1x2 @ 29"
2 - 1x2 @ 9 3/4" (Short point to short point, both ends cut at 30 degrees off square, NOT parallel to each other)
6 - 1x2 @ 9"
4 - 1x2 @ 10 1/2" (Long point to long point, both ends cut at 30 degrees off square, NOT parallel to each other)
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Instructions
Step 1
Step 2
Step 3
Step 4
Step 7
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.
Comments
Jaci (not verified)
Tue, 05/31/2011 - 06:53
Thanks, Ana. I was looking
Thanks, Ana. I was looking for something just like this for a spot near the house. I appreciate all that you post. This is the summer for all the projects I have saved!
Jaci
annalea
Tue, 05/31/2011 - 13:14
These look great! I do have
These look great! I do have one question, though. What keeps the shelves from sliding down the back leg? I know they're attached with bolts in front, but it seems like the angle of the back of the shelf wouldn't be enough to hold much weight. Did I miss some cleats somewhere?
britt (not verified)
Tue, 06/07/2011 - 05:38
Yes, I had the same issue
My shelves also slide down the back of the leg (both top and bottom shelf). I think I might put toggle latches to prevent this or add two dowels and run a strip of canvass between. This will keep the legs from opening wider.
Guest (not verified)
Tue, 06/07/2011 - 09:30
"Yes, I had the same issue
The two 29" pieces (horizontal) hang over the edge of the legs preventing the front legs of the shelf from rotating too far forward. Hope this helps.
Line (not verified)
Wed, 06/29/2011 - 00:30
Is is adaptable?
Thanks, Ana, for this great project, once more!
I ahve a question, though: do you think it is adaptable to make a folding table?
I would really need to make one to enjoy summer dinners on my apartment's balcony, but I've never made anything out of wood, so I really can't figure out what to do...
Thanks for your help!
steffie (not verified)
Mon, 03/05/2012 - 19:29
Thank You
Thank you very much you have helped me alot with my prodjuct that I have to do for school. Now I know who to go to for any advice. Oh and once agian, Thank You.