Build this armoire with open storage and concealed storage behind magnetic metal doors. Industrial chic with just a touch of metal, this cute kids room DIY project contains free step by step furniture plans to build!
5 - 1x12 @ 6 feet long
1 - 1x4 @ 6 feet long
2 - 1x2 @ 8 feet long
2 - 1x3 @ 8 feet long
20" wide tin flashing roll, 4 feet long
2 sets of hinges
Optional 3/4" x 3/4" cove moulding
1 sheet 1/4" plywood
2 - 1x12 @ 71 1/4"
1 - 1x12 @ 36"
5 - 1x12 @ 34 1/2"
1 - 1x4 @ 36"
1 - 1x4 @ 34 1/2"
1 - 1x2 @ 36"
1 - 1x2 @ 37 1/2"
1 - 1x2 @ 39"
4 - 1x2 @ 11 1/4" (Width of 1x12)
4 - 1x3 @ 20 1/2"
4 - 1x3 @ 17 7/8"
1 - 1/4" plywood @ 72" x 36"
If you can't find 1x12s that are straight or would like to build a wider width armoire (deeper storage) then replace the 1x12s with plywood cut into strips to your desired widths. Recommended widths to use up your plywood are 11 3/4" and 15 3/4" or 23 3/4". Choose PureBond Formaldehyde Free Plywood for a formaldehyde free alternative.
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Build the cabinet box as shown above, using either 3/4" Kreg Jig holes and pocket hole screws or 2" screws and glue, countersinking screws. Adjust the box for square by taking a diagonal measurement from opposite corners, ensuring measurements match. Bottom, middle and top shelves must be fixed, remaining shelves can be adjustable or fixed at different heights. You can also use 1x10s for the non-fixed shelves for a different look or inset doors.
I built door frames as shown above using the Kreg Jig, with pocket holes set for 3/4" stock, 1 1/4" screws. Then I finished the empty frame and painted. Finally, I stapled the tin flashing to the back with 3/4" staples. I also filed sharp points from the tin flashing and covered the edges with clear tape.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.