Barnwood Frame - Variation

Submitted by Joni on Fri, 02/10/2012 - 08:48

Have you checked out prices at framing stores lately? Since I didn't want to pay $250 for a frame, I decided to make one out of some spare 1x4 Douglas Fir that I had. It's a single board with a router cut at the edge for detailing. I routed a rabbet onto the back, and kreg-jigged it together. I distressed the wood by beating it with a hammer and chain.

Prior to completing the frame, I took a sample piece to the framing store (who would be matting it) to make sure they could work with my rabbet size. I ended up having to make it deeper and wider to accommodate them, so I would advise doing this if you're taking it to a framer.

I never dreamed I could actually make a frame, much less a piece of furniture. Thanks so much to Ana for sparking all of this. I've found my creative calling thanks to her!

Estimated Cost
Free (spare wood!)
Estimated Time Investment
Afternoon Project (3-6 Hours)
Finish Used
1. Minwax water-based wood conditioner. 2. Minwax mix of Onyx & American Walnut water-based stain. 3. General Finishes Glaze in Van Dyke Brown. 4. Bartley's Satin Polyurethane (4 coats).
Recommended Skill Level
Beginner

Comments

Becky Smith (not verified)

Thu, 02/16/2012 - 04:32

That is really beautiful! I've been considering the same build for the same reasons. Framing costs are outragous! I've never used a router before and I guess I'm a little intimidated by them. What do you think? Are they too hard to use? Worth investing in?

Thanks!

Joni

Tue, 02/21/2012 - 08:11

Becky -- thanks for the feedback. The router is hard for me, but I don't think I know all the ins and outs of how to use it. For making the rabbet on the back, I've found out that a table saw works SO MUCH BETTER than trying to use the router. I believe that a dado blade for the table saw could make the decorative cut (and much easier, faster, and cleaner than trying to use the router).