How to build A Frame Chicken Coop - portable and small with built in nesting box and perch. You'll love our easy to follow free plans from Ana-White.com. Builders spend about $100 building this coop.
UPDATE: I have created new, updated plans for this chicken coop here.
- 14 - 2x4s, 8 feet long
- 1 - sheet 3/4" t1-11
- 6 total T-Strap hinges
- 30 feet of 30" wide chicken wire (I used 36" because I couldn't find 30" locally)
- 2 3/4" exterior self tapping deck screws
- 1/2" exterior staples for chicken wire
- scrap plywood piece for floor of upstairs coop and ladder
- Optional 1x2s for trim out if desired
- 6 - 2x4 @ 64" (Long point measurement, top end cut at 60 degrees off square, bottom end cut at 30 degrees off square)
- 6 - 2x4 @ 96"
- 2 - 2x4 @ 64" (Long point measurement, both ends cut at 30 degrees off square)
- 5 - 2x4 @ 32" (Long point measurement, both ends cut at 30 degrees off square)
- 4 - pieces t1-11 siding cut into 24" x 48" pieces
- Optional 1x2 trim
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Cutting the top angle is going to be a pain - I know - if your miter saw does not cut 60 degree angles. What you will need to do is mark the angles with your square and then cut with a circular saw. Remember, it's 60 degrees off square.
Once you have your rafters cut, then you can simply attach the side support boards. NOTE: I left a 24 1/2" gap for 24" wide t1-11 - you may wish to leave a slightly wider gap for easier access to the upstairs coop - or you can cut your plywood down to fit.
Another trick here is to cover the bottom with chicken wire. These things are always easier done now rather than when you are inside the coop :)
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.