This bed heavily relies on the information provided in the Hailey Storage Bed plans, so please review that plan for detailed instructions and to build the storage bench.

Build the headboard panel as shown above. Please review step 3 because and the Hailey Storage Bed Plan, because this bed assumes that you ripped your 2x4 legs down to 3" wide (take 1/4" off each edge to make the edges nice and square). You will need a table saw to do this right. But you can use standard with 2x4s by simply subtracting an inch to the panel and trim (so you would cut your panel 71" wide and the trim 71" wide too). Attach trim as shown above.

The best way to get a nice tight joint here is to use pocket holes drilled every 8-12" on the back, with the jig set to 3/4" stock. Use glue and attach with 1 1/4" pocket hole screws. It's going to be tricky to drill these pocket holes, so get some help holding that plywood up :)

Now we simply add the top trim as shown above.

Now it's time to build the arms - which are basically taller footboards from the Hailey Storage Bed plans. Build exactly as the headboard - with the different dimensions. Remember that the dimensions shown above are for legs made from 2x4s that are ripped down to 3" wide. If you use off the shelf 2x4s, you will need to subtract and inch from the panel and panel trim.

Now the exciting part, the can't wait till the hubs gets home to help me haul it into the house and assemble it! You've made the bench, you made the arms, and the headboard. Now assemble as shown above, without the slats. Start in this order: 1) attach the arms to the front bench with 2" screws from the insides of the cubbies into the legs of the arms 2) attach the headboard to the arms with 2 1/2" screws from the back into the legs of the arms 3) adjust so that the spacing for the mattress is square 4) take a measurement of the slat length and cut your slats to fit 5) screw slats down and put your mattress on top!