DIY Potting bench plans!
7 - 2x4 @ 8 feet long (Cedar or exterior treated works best for exterior applications, but well sealed lumber can also work if properly treated and maintained)
1 - 1x6 @ 8 feet long
1 - 1x3 @ 8 feet long
1 - 1x2 @ 4 feet long
10 - 2x4 @ 36" (Shelf Boards)
4 - 2x4 @ 19 1/2" (Shelf Supports)
2 - 1x2 @ 19 1/2" (Center Shelf Support)
2 - 2x4 @ 36" (Front Legs)
2 - 2x4 @ 48" (Back Legs)
2 - 1x6 @ 39" (Top Shelf)
2 - 1x3 @ 39" (Back Supports)
Cut largest boards first to minimize waste.
Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck!
Begin by attaching the shelf boards to the side supports as shown above. Choose exterior decking screws installed correctly (see packaging) to prevent water damage. If you have a Kreg Jig™, you could also fasten from the underside and completely hide all screw holes. Take care to ensure that both (Yes, make two) shelves are square. Glue is advisable.
It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed.
Because this project is likely to be used outdoor, treat with an exterior finish for added durability, and refinish as needed to protect the wood.