Small Pub Table

Submitted by Sbarker645 on Wed, 12/28/2016 - 14:40

Tried to post this under Old Man's pub table post, but couldn't load a photo in the comments section. This is a similar table, but a 2x6 shorter and breadboards are one ripped 2x6, not two 2x6s. Final dimensions were 43" high by 39"x36.5". Built the top with Kreg Jig and screws like most tables on the site. Base is 4x4s with 2x4 I-beams Kreg jigged into 4x4s.

Estimated Cost
$65
Estimated Time Investment
Week Long Project (20 Hours or More)
Finish Used
Minwax Golden Oak 210B, about 3 coats with sanding and evening of finish in spots where it didn't take well. Poly clear coat on top
Recommended Skill Level
Beginner