Reclaimed Wood Night Stand

Submitted by bRick on Thu, 06/11/2015 - 21:48

These (matching set) were a pretty straightforward build based on the Reclaimed Wood Night Stands. http://ana-white.com/2011/08/reclaimed-wood-night-stand. The hardware I used was designed to match the Printer's Console that I built previously. I cheaped out on the drawer slides, which I wouldn't recommend doing because it gives the drawers a cheap feel to them. Plus, there's not that much of a price difference.

Estimated Time Investment
Week Long Project (20 Hours or More)
Finish Used
Rustoleum American Oak
Recommended Skill Level
Beginner

Comments

blue72vette

Fri, 04/08/2016 - 13:54

Hello, your project looks nice. Did you use regular #2 lumber from Home Depot or Lowes? If so how are they holding up?

bRick

Wed, 10/05/2016 - 16:59

But yes the lumber was straight outta Home Depot. I would say its doing pretty good at this point. It sees pretty light duty (e.g. alarm clock, books and glasses of water), but no water rings. I did throw a number of coats on the top of it though. It's soft wood, so if you wanted to you could engrave your name with your thumbnail. You just have to resist the urge.