Barn Door Console

So this project took quite a while for me to finish, but I didn't cut any corners and expanded a bit on the basic plans that were offered.  Some notes on changes to the project:

• Instead of leaving the gap in the bottom and middle shelves, I used a second 1x10 and ripped it down to the exact width I needed so that it would be flush (this was done for the bottom shelf and the middle shelf.
• I added 3 supports in Step 5 at the back to provide additional support for the middle shelf.  
• For the top, instead of 2 2x10's, it is 3 2x8's ripped down to 6.25" each, then edge glued.  A brace was then added to the bottom and used to attach the top to the main unit.  See the pictures for a better description.  
• I also edge glued the doors out of 1x6's in order to get the dimensions I wanted.
• I used a 1x3 at the bottom to give it more of a sturdy look
• OK, so the big part that people complained about the original plans were the lack of information on how to do the rails.  I cheated and contacted a metal fabricator to make them for me.  Pricing was consistent with what you would find online for similar barn door hardware, but it definitely turned out better than me trying to do it myself. 
• The stain is Minwax "provincial" and I used a wipe-on poly to coat it.  For the top, I used 400 grit sand paper between coatings, and let me tell you, you can see your reflection in the finished product.  Turned out really well!
• My only regret is that I used project boards for the two end pieces, and so they don't quite match the remainder of the project.  I would have edge glued them just like I did the doors given the chance to do it over. 

Anyway, enjoy!