I built this wine cabinet for some friends on their wedding day and still really love it! Don't try this as a beginner, but if you want an inexpensive method of storing wine and wine glasses, this might just be your plan.
3 - 1x2 @ 8 feet long
1/2 sheet of plywood
A) 11 - 1x2 @ 7 1/2" stemware verticals
Work on a clean level surface. Take a square of your project. Use 2" nails and glue unless otherwise directed. Use proper safety equipment and guidelines. Also, you may wish to paint the smaller pieces first. From experience, it's going to be tough getting a brush in the stemware holders.
Stemware Holders. Begin by building the stemware holders by building 2 L-Shaped pieces with boards A and B and 9 T- Shaped pieces using A and C as shown above. If you are painting the piece with a brush, I recommend painting these pieces and board D now, because it will be very difficult to reach once this is put together.
Top Crown. Attach the top crown pieces, the sides first, and then the front. Nail into both the bottom crown piece and the hutch. I like to router out the bottom outside edge of the top piece.
10. Back. Add the plywood to the back. I like to use beadboard.
And that is it! Fill nail holes with wood filler and, sand and finish as desired. Once in place, I recommend you attach to the wall to ensure there are no accidents.